
Short answer: there is no universal bulb chart by model, and any page that gives one number for a car is guessing. The same nameplate changes bulbs between model years, trims and markets — a sedan may use one type in the base trim and another in the top trim, and the Mexican version of a model does not always match the US version. The only reliable source is the car itself: the code etched on the old bulb, the moulded marking on the lens or housing, and the owner's manual. This guide walks the three in order, and covers what to do when the car is imported or the headlight has been replaced.
Step 1 — Read the code etched on the old bulb
The code sits on the metal collar or the plastic base, and sometimes on the glass. This is the number that decides everything. The ones you will meet most in Mexico: H4 (one piece with two filaments, low and high together), H7 (single filament), H11, 9005/HB3, 9006/HB4, 9012/HIR2 and, on older cars, H1 and H3. Wattage (55W, 60/55W) tells you what the halogen consumes, not the fit: two 55W bulbs can be an H7 and an H11.
- Switch the car off and let the headlight cool — a lit halogen burns.
- Wear glasses or nitrile gloves. Grease from your fingers on a halogen glass shortens its life.
- Turn the connector or rear cap and pull the bulb straight out; if it resists, there is a clip or a lock.
- Photograph the code before refitting — that photo is your reference for the next purchase.
Step 2 — Find the moulded marking on the headlight
Lenses and housings carry raised markings: approvals (DOT, ECE/SAE), the headlight maker's code and, on many models, the bulb type itself (HB3, HB4, H7). Check the lower edge of the lens and the area hidden by the bumper or facia. This marking matters most when the old bulb is unreadable, when the car runs bulbs that are not factory, or when you suspect the headlight was replaced after a hit.
Step 3 — Confirm with the manual, by year and trim
The owner's manual has a bulb table by position (low beam, high beam, fog, indicators). Use it together with the exact year and trim: model-year changes and facelifts replace the whole headlight, and one name can take an H4 in 2014 and an H7 in 2018. If the manual is gone, the code on the old bulb is still your best source; if the old bulb is gone too, go to the lens marking before any chart on the internet.
| Socket family | Where it usually shows up | What to confirm before buying |
|---|---|---|
| H4 (twin filament) | Budget and compact cars of Asian design, mostly 2000–2015 | Whether the headlight uses one piece for low and high |
| H7 (single filament) | European platforms: VW, Seat, Audi, BMW, Mercedes, Peugeot, Renault | Whether it runs low, high or both (varies by model) |
| H11 | Low beams and fog lamps on many recent cars and SUVs | Whether the position is low beam or fog |
| 9005 / HB3 | High beams on North American pickups and SUVs | It is almost always the high beam, not the low |
| 9006 / HB4 | Low beams and fog lamps on North American pickups and SUVs | How many positions on the lamp use 9006 |
| 9012 / HIR2 | Some recent projector-headlight models | Whether the lamp is a projector and whether the cap closes over a heatsink |
Never fit a different socket 'because it looks the same'. 9005 and 9006 look almost identical but are keyed differently: forcing one puts the filament in the wrong position, wrecks the beam pattern and can damage the holder.
If the car is imported or the headlight was replaced
Imported used cars usually carry US-spec headlights, which do not always use the same bulb as the version sold new in Mexico. The same is true of collision-repair lamps: a generic replacement may take a different base. In those cases check both sides — some cars left the factory with different families for low and high — and do not assume the bulb that was in there was correct: the previous owner may have swapped it.
How to order the right bulb the first time
- Model, year and trim (base, mid, top): trim changes the headlight more than people expect.
- Position: low beam, high beam or fog. If low and high are one piece, say so explicitly.
- A photo of the old bulb where the code is readable, or of the lens with the raised marking.
- How many pieces you need: one headlight can use two different bulbs.
How do I know whether my car uses H4 or H7?
Count the filaments. The H4 carries low and high in one piece (two filaments, three base tabs); the H7 has a single filament. If the old bulb has two contacts and an internal metal shield, it is an H4. Even so, the code etched on the base outranks any deduction.
Can I switch from halogen to LED on the same socket?
Yes, the socket does not change: an H7 LED goes where an H7 halogen was. What changes is the result. In an old reflector lamp a poorly positioned LED scatters light and glares; in a projector lamp with a sealed cap the heatsink sometimes will not fit. Check the space behind the bulb before buying.
Do all cars accept LED bulbs?
Almost every halogen car can take an LED on the same socket, but not every car does it well. Projector lamps with room for a heatsink give the best result; open reflectors and sealed caps are the hard cases. If the car has a bulb-out warning, you also need an LED with a CANbus decoder.
What happens if I fit the wrong bulb size?
It will not seat, or it will seat only when forced: the seal fails, moisture gets into the lamp, the beam pattern sits high or scatters and the connector can overheat. In the best case you return it; in the worst you damage the holder or the whole headlight. Confirm the code before buying.
Do cars sold in Mexico use the same bulbs as in the United States?
Not always. The same platform can ship with different headlights per market, and imported cars keep the specification of their country of origin. If your car came in used from the US or Japan, confirm on the headlight rather than on the spec sheet for the model sold here.
Shop LED headlight bulbs by size
Wholesale buyers order by socket, not by series code. Pick a base to see the Chedina models listed for it, with specs and a quote path — and confirm the exact base before ordering.
Related reading
Short answers to the questions buyers ask us most.
